+86-573-84665511info@jxtisen.com

Categories

ADD: Room 101 Ground Floor, No.55 Fengli Road, Dayun Town, Jiashan, Zhejiang, China

PHONE: +86-573-18157320188

TEL: +86-573-84665511

FAX: +86-573-84665689

E-mail: info@jxtisen.com

susan.xu@jxtisen.com

lucy.luo@jxtisen.com

Website: www.jxtisen.com

Home > News > Content

The Processing And Movement Characteristics Of Bushing

     Processing:

     Thick-walled bushing can be cast, in order to improve the friction performance, can be cast in 

the bearing surface of a bearing alloy. In order to make the bearing alloy and bearing attached to 

the well, often in the inner surface of the bearing on the various forms of tenon, groove or thread.

 Thim-walled bushings can be bimetallic continuous rolling process and other large-scale production.

      Powder metallurgy is the powder of iron or copper and other basic materials mixed with 

graphite, and then pressed sintering forming. The pores can be stored lubricants, called oil bearing.

      The bushing material is usually softer, the inner cylindrical surface should not be processed 

by grinding, can be boring, King Kong boring, scraping or grinding processing. Grinding should not 

not be used with the shaft diameter with the method of research, but should use a special size and 

size of the same hole diameter rod. Scraping for the part of tile bearing, scraping with a wide

blade scraper. Hand scrape, scratches should be shallow. The inner surface of the complex shape of 

the bearing, should be based on the specific shape of the use of special boring method.

      

     Movement Characteristics:

     Sliding bearing work, between the bearing pad and the shaft requires a thin layer of oil film 

from the lubrication effect. If there is a direct friction between the bearing pad and the shaft, 

the friction will produce a very high temperature. Although the bearing pad is made of a special

high temperature resistant alloy material, the high temperature generated by direct friction is 

still sufficient to burn it. Bearings may also be due to the load is too large, the temperature is 

too high, there are impurities in lubricants or viscosity abnormalities and other factors caused by 

burning tile. After the burning of the sliding bearing on the damaged.